Wireless -> Advanced Settings (leave everything to default).This option is also available on the mobile hotspot). (optional - specify MAC address of devices allowed on the network if you want to restrict access to certain devices only Virtual Interfaces- Encryption has to match mobile hotspot encryption (these are settings that worked for me) Key Renewal Interval (in seconds): 3600 (default).Physical Interface- Encryption has to match mobile hotspot encryption (these are settings that worked for me) Wireless -> Radius (skip this, only configurable in AP isolation mode anyway) Wireless SSID Broadcast: Enable (or Disable if you want to hide the network).Wireless Netwrok Name (SSID): WIFI_2 (or any other name).Sensitivity Range (ACK Timing): 2000 (default) unless you know what your doing.
Wireless Network Name (SSID): WIFI_1 (same as phone hotspot).Wireless Network Mode: Mixed or choose G-Only.Assign WAN Port to Switch: (Optional) select if you want to make an extra ethernet port available for an additional device.set local IP address of router to 192.168.43.2.You should be greeted with a page inviting to set admininistrator user and password. reset router by pressing the hardware switchĬonnect to open wifi dd-wrt or use an ethernet cable instead.Connect a device to check ip address range and subnet mask.Timeout Setting: Never Timeout (optional).Hide my device: unselected (optional, select if you want to hide SSID).Password: choose your own wifi password.Note: Click 'Save' everytime you change a settings, once all settings have been modified select 'Apply Settings' and wait for router to reboot.
(Broadcom BCM5352 chip rev 0) flashed with dd-wrt firmware v24-sp2 (07/22-09) micro - build 12548M NEWD EkoĪny wifi modem router could also be used instead or any other phone with hotspot function but the point here is to explain how to share mobile phone internet with wired devices Hardware used in this tutorial Linksys WRT54G/GL/GS
Most of the settings are left to their default values. I have included screenshots of most config page so you can check your own configuration but This assumes you have a router flashed with dd-wrt and repeater bridge option available. How to share mobile internet (wifi hotspost) to wired ethernet (LAN) devices with dd-wrt